EdgeStar AP12000S-1 Owner's Manual download pdf (Page 12)

Your portable air conditioner is designed to exhaust condensate

water that is collected from the air. This water, in either gaseous or

droplet form, will be expelled out the exhaust port of the unit.

Please take this into account when deciding how to vent it.

1. The exhaust hose supplied with the portable air conditioner can

be extended up to 48 inches; however for maximum efficiency, use

the shortest length possible.

2. Try to prevent any kinks or bends in the exhaust hose. Kinks or

bends may trap exhaust air which can radiate heat into the room or

potentially cause the portable air conditioner to overheat and shut

itself off.

3. The exhaust hose supplied with the portable air conditioner has

been specifically designed for this air conditioner. Do not lengthen

the hose by adding additional hoses or attachments or replace it

with any other hose.

Do not lengthen the

exhaust hose by adding

additional hoses or

attachments.

Warning: Longer hoses are not recommended.

Draining the Unit

When the portable air conditioner is in cooling mode, or dehumidify

mode, it will remove moisture from the air. The condensed water

from the air will be collected in an internal reservoir and will be

evaporated and exhausted out of the exhaust hose. However, in

very humid conditions, the internal reservoir may fill completely.

This causes the air conditioner to turn off to avoid overflowing the

internal reservoir. The WATER indicator will light up on the Control

Panel.

Direct drainage

1. Remove the rubber drain plug from the drain port.

2. Connect a drain hose to the drain port.

The portable air conditioner will now drain through the drain hose.

Please note that this unit has no drain pump; all water will drain

with gravity only, i.e., only “downhill.”

Notes about the Exhaust

hose

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

No comments

EdgeStar AP12000S-1 Owner's Manual Page 12