EdgeStar BR7000SS Owner's Manual download pdf (Page 7)

Installing the Kegerator

The kegerator should be installed in accordance with local electrical code

requirements. The kegerator should also be placed in a location that is

strong enough to support its total weight, keeping in mind that it will weigh

substantially more when fully loaded than when empty.

Before you plug the kegerator into a power supply, be sure to let it stand

upright for at least 24 hours to allow the compressor's oils to settle.

Unpacking the Kegerator

WARNING: Use two more people to move and install the kegerator.

Failure to do so can result in back or other injury. Carefully remove the

packaging materials. Remove any shipping tape and glue from your

kegerator before using. Do not use sharp instruments, rubbing alcohol,

flammable fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your kegerator.

IMPORTANT: Do not remove any safety, warning, or product information

labels from your kegerator.

Electrical Requirements

ELECTRIC SHOCK HAZARD!

• Plug into a grounded 3-prong outlet.

• Never remove the grounding prong from the plug.

• Never use an adapter to bypass the grounding prong.

• DO NOT use an extension cord.

• Failure to follow these instructions can result in fire,

electrical shock, or death.

Before you move your kegerator into its final location, it is important to

make sure you have the proper electrical connection:

A standard electrical supply (115 V, 60Hz), properly grounded in

accordance with the National Electrical Code and local codes and

ordinances, is required.

It is recommended that a separate circuit, serving only your kegerator, be

provided. Use receptacles that cannot be turned off by a switch or pull

chain.

The fuse (or circuit breaker) size should be 3 Amps.

Recommended grounding method

For your personal safety, this appliance must be grounded. It is equipped

with a power supply cord having a 3-prong grounding plug. To minimize

possible shock hazard, the cord must be plugged into a mating 3-pronged

wall socket, and grounded in accordance with the National Electrical

Code and local codes and ordinances. If a mating wall socket is not

available, it is the personal responsibility of the customer to have a

properly grounded, 3-prong wall receptacle installed by a qualified

electrician.

EdgeStar Built-in Kegerator 4

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Comments to this Manuals

No comments

EdgeStar BR7000SS Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Drink coolers EdgeStar BR7000SS