EdgeStar BR7000SS Owner's Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 19
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
OPERATION
Installation Check List before Operation
1. Have all packing materials and tape been removed from the
interior and exterior of the kegerator?
2. Have the installation instructions been followed, including
connecting the machine to electricity? And has proper grounding
been installed for the kegerator?
3. Has the machine been leveled?
4. Is the kegerator in a site where the ambient temperature is
between 50 ° F and 95 ° F all year round?
Using the Temperature Control Panel
I Power Button I I RunLight I I Temperature Display
---., \ /
%
1ITemo.AdjustO0I
J
Use the up and down buttons to adjust the temperature. The temperature
displayed can be in Fahrenheit or Celsius. This kegerator has a
temperature range from 32°F to 60°F.
Note: Whether your
kegerator can reach the
actual set temperature
depends on the ambient
environmental conditions.
This kegerator has one display. The unit will display the current
temperature inside the cabinet. Once you press either the or button
the display will switch to show the set temperature. When the desired
temperature is set the display will revert back to show the current
temperature after 5 seconds. Note: It is normal to see the set
temperature and current temperature displays being a few degrees off
from each other.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
Press the button on the control panel to lower the temperature by 1
degree increments.
Press the button on the control panel to increase the temperature by 1
degree increments.
Press the 2,._t_button to turn the inner light on or off.
Press and hold the power button for approximately 3 seconds to turn the
unit's power on or off. The Run Light will illuminate when the unit is
working.
The Celsius or Fahrenheit light will be lit depending on what scale
temperature is being displayed. To switch between C and F, press and
hold the and buttons at the same time for approximately 5 seconds
until the temperature scale changes.
EdgeStar Built-in Kegerator 10
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments