Edgestar MINI KEGERATOR TBC50S User Manual download pdf (Page 13)

EdgeStar Mini Kegerator 10

Removing the CO

line and mini keg

Once your mini keg is consumed, you need to shut off the CO

and

remove the keg.

 Open the compartment located on the right-hand side of the mini

kegerator.

 Shut off the regulator (turn the knob counter-clockwise).

 Put a container under the dispenser and pour off any remaining

beer (this will also relieve some of the pressure in the mini keg).

 Open the mini kegerator main door and disconnect the CO

line

and beer line.

 Empty the remaining CO

from the mini keg with the CO

releaser

as shown:

 Undo the tap from the mini keg by releasing the catch (on the top

of the tap) and pulling it up and out of the mini keg):

 Rinse the tap out under running water. You should also clean it

with a mild detergent solution and rinse it thoroughly.

 Clean the lines as directed in the under “Cleaning and

Maintenance” section.

Note that the optional accessories include a cleaning kit that uses CO

pressure to force the cleaning solution through the lines. To use this

system, fill the cleaning kit half full with your choice of cleaning solution

(water mixed with a bit of beer line cleaner, baking soda, or white

vinegar), connect it to the unit as if it were a non-pressurized mini keg,

and pour out all of the solution. Make sure to rinse the lines again!

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Edgestar MINI KEGERATOR TBC50S User Manual Page 13