EdgeStar IB450SS User Manual download pdf (Page 15)

provided you have access to a water supply and a drain. You must follow the stated

instructions for

a- Electrical requirements

b- Water supply and drain

c- Leveling the icemaker.

Recessed installation:

A recessed installation will allow you to install the ice maker under a counter, or in a

kitchen cabinet provided the required clearance space around the ice maker is respected.

This installation has the same requirements as a built-in installation.

Built-in installation:

If this method of installation is chosen, it will still be necessary to allow adequate

ventilation space around the unit (make sure there is at least some ventilation room for the

back of the unit). The following additional items must be observed.

1. Place ice maker in front of installation location. Remove the feet and place the unit

flat on the floor or on a platform depending on your installation requirements.

2. The water supply pipe must be plumbed before connecting to the ice maker. Install the

drain line into your drain.

3. Turn on main water supply and tap. Check for water supply connection leaks. Tighten

any connections (including connections at the tie-in).

4. If electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.

5. Push the ice maker into position.

6. Seal all around the cabinet to the floor with an approved caulking compound.

OPERATION

Final Check List before Operation

1. Have all packing materials and tape been removed from the interior and exterior of the

ice maker?

2. Did you clean the ice storage bin?

3. Have the installation instructions been followed, including connecting the machine to

water and electricity? Does the unit have proper drainage?

4. Has the machine been leveled?

5. Is the ice maker in a site where the ambient temperature is between 50º F and 100ºF

and the water temperature between 41º F and 90º F all year round?

6. Has the water supply pressure been checked to ensure a minimum of 15 psig with a

static pressure not to exceed 80 psig?

7. Is there a clearance of at least 2/5” at the rear, 1” at the top and 1/5” at the sides for

proper air circulation?

8. Has the power supply voltage been checked or tested against the nameplate rating?

And has proper grounding been installed for the ice maker?

9. Is the ice maker plugged in?

10. Have you turned on the main water supply and the tap?

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

No comments

EdgeStar IB450SS User Manual Page 15