EdgeStar AP10001B Owner's Manual download pdf (Page 12)

Draining the Unit

The unit will need to be drained if set to dehumidify mode. When the

portable air conditioner is in cooling mode, it will remove moisture from

the air. The condensed water from the air will be collected in an internal

reservoir and will be evaporated and exhausted out of the exhaust hose.

However, in very humid conditions, the internal reservoir may fill

completely. This causes the air conditioner to turn off to avoid overflowing

the internal reservoir. The unit will beep 8 times and the LCD will show a

“P1” error code on the Control Panel if the reservoir is full of water. The

fan motor will continue to run, but the air conditioner/ dehumidifier will

stop running.

Direct drainage

For continuous use you can connect a drain hose to the upper drain port

of the portable air conditioner.

1. Remove the rubber drain plug from the upper drain port.

2. Connect a drain hose to the upper drain port. (Some models may have

a threaded valve for a garden hose. You may need to purchase an

adapter.) The portable air conditioner will now drain through the drain

hose. Please note that this unit has no drain pump; all water will drain

with gravity only, i.e., only “downhill.”

Manual Drain

You may need to manually drain the unit if your unit stops running and

displays a “P1” error.

1. Roll the unit to a location suitable for draining.

2. Remove the lower drain plug and allow the unit to drain completely.

3. Insert the lower drain plug to the lower drain port and restart the unit.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

No comments

EdgeStar AP10001B Owner's Manual Page 12