Troubleshooting and reconnecting wires to the “compressor capacitor” on the AP550Z Tools required: Phillips screwdriver The problem: If the AP550Z w
4. Once the filter frame has been removed, remove the lower portion of the back of the unit: Once the screws have been removed, this portion comes r
Step C. Pull the panel down and off the unit Step B. Remove these two screws. 6. Locate the “compressor capacitor”. It is a silver cylinder that is
7. Look at the wires going into this capacitor- there should be four wires and one bare terminal. A view of the capacitor from below A close-up of
8. If any wires are not connected, connect them. The three blue wires all connect to one terminal, and the one red wire connects to a terminal all by
Comments to this Manuals