EdgeStar IB450SS User Manual

IB450SS Clear Ice Maker Owner’s Manual This owner’s manual provides instructions on safe installation, use, and maintenance.

z To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amou

The ambient operational temperature should be between 50℉ and 100℉. The operating water temperature should be between 41℉ and 90℉. Operati

Before you move your icemaker into its final location, it is important to make sure you have the proper electrical connection: A standard electrical s

To remove door from hinges: 1. Using a Phillips screwdriver, remove the screws and take off top hinge. Keep the parts together and set them aside. 3.

IMPORTANT: 1. All installations must be in accordance with local plumbing code requirements. 2. Make certain that the pipes are not pinched or kink

provided you have access to a water supply and a drain. You must follow the stated instructions for a- Electrical requirements b- Water supply and dra

11. Have you checked for leaks at all water supply connections- and at the drain? Operating Method 1. Turn on the water tap, let the water trough fil

There are two distinct cycles: freeze and harvest. During the freeze cycle, water flows to the evaporator surface. In the harvest cycle, the ice is re

z Water running from the evaporator to the water bin may make a splashing sound. z As each cycle ends, you may hear a gurgling sound due to the refr

There are 5 things to keep clean: 1. The exterior. 2. The interior. 3. The condenser 4. Water distribution tube 5. The ice-making system Ext

User’s Manual Clear Ice Maker Installation only by a licensed plumber. Be sure to stand the ice maker upright for at lea

Condenser Cleaning A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and causes higher than recommended operatin

Minerals that are removed from water during the freezing cycle will eventually form a hard scaly deposit in the water system. Cleaning the system regu

Descriptions of LEDs and buttons: 1. Ice Full (Red) LED: Ice Full indicator light. When this LED is lit, the ice storage bin is

and the ice size will be smaller in the next cycle. IMPORTANT: • It is not recommended that the ice size be adjusted unnecessarily since this could d

Problem Possible Cause Probable Correction The icemaker is unplugged. Plug the ice maker in. The fuse is blown. Replace fuse. The icemaker power s

LIMITED WARRANTY This EdgeStar product is warranted to be free from defective workmanship and materials for the first year following the date of origi

Once an EdgeStar authorized representative has confirmed that your product is eligible for warranty service, the product must be returned to our EdgeS

For product guides, additional troubleshooting resources, and up to date information, visit us on the web at: http://www.edges

Thank you for purchasing this EdgeStar product. We are glad you chose us. We believe that your purchase of this product opens a relationship between y

TABLE OF CONTENTS Page ICE MAKER SAFETY………………………………………………………………… 5 IMPORTANT SAFEGUARDS………………………………………………………. . 6-7 TECHNICAL INFORMATION………………………

ICE MAKER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your

IMPORTANT SAFEGUARDS Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefu

first batch of cubes must be discarded. z Never turn the water supply tap off when the ice maker is working. z If the ice maker will not be used for

Note on ice storage This type of icemaker produces crystal-clear, gourmet cube ice. An insulated ice storage bin is built into each the icemaker. The

Ice scoop Figure 1 Power supply Control panel Water inlet Ice scoop Drain hose ICE MAKER INSTALLATION